The specialty grade alumina project has been completed with success.
Available now, alumina based filler additive to reduce consumption of TiO2 in paints, paper and other industries.
Bee Chems to venture into manufacturing of Fine Silica powders for Clinical Applications.
Bee Chems to work on producing next generation desiccants for total moisture protection and control
They explain every thing about the product and its use in detail and put their best efforts to make customer understand the applications and results!
The service and products were great!
‘I am amazed to see the speed at which this company responds and executes orders!’
--Sri, Cambridge Solutions, Bangalore.
First Indian Company to Manufacture Colloidal silica
Manufactures Maximum grades of Nano Silica Products
First Indian Company to Manufacture Activated Desiccants
Technical support and suggestions for modifications and upgradation of process plants using adsorbents in refineries, fertilizer and petrochemical plants
Producers of maximum variety of Desiccants in the World
Rheology Modifier Clays
BS-1C-FF is an organo-clay for solvent-based systems of low to medium polarity.
|Color||Appearance||Density||Moisture (@105°C,2hrs)||Mesh Size (200 mesh)||Loss on Ignition (@1000°C)|
|Light Yellow||Free Flowing Powder||1.75g/cm3||<=3.5%||>=97%||<=33.0%|
BS-1C-FF belongs to the conventional type of organo-clay group, which requires mechanical energy, shear forces applied with a good dispersion equipment, and a chemical (polar) activator to reach the proper level of delamination of the organo-clay particles.
Polar Activator: Dosage of polar activator (such as 95%ethanol, 95%methanol, 95%acetone or propylene carbonate) is 30%-50% by weight of BS-1C-FF.
It is always recommended to determine the proper level of addition by experiment. Either defect or excess of chemical activator would result in poorer viscosity development.
The amount of BS-1C-FF rheology modifier required depends upon the type of organic system and the degree of thickening or other properties desired. Addition levels are typically between 0.50-2.0percent by weight of the total system.